Code Alarm 1000SX Instalační příručka stáhnout pdf (Strana 15)



4.3 Power Supply Wiring and Grounding

Figure 15: RSG2000 Series Philips Screw Terminal Block

Figure 16: RSG2000 Series Phoenix Plug Terminal Block

The RSG2000 Family supports dual redundant power supplies – “Power Supply 1 (PS1)” and

“Power Supply 2 (PS2)”. The connections for PS1, PS2 and the fail-safe relay are located on the

terminal block as shown in Figure 15 and Figure 16.

The RSG2000 Family can be equipped with either a Philips Screw Terminal Block or a Phoenix

Plug Terminal Block. The Philips Screw Terminal Block has Philips screws with a compression

plate allowing either bare wire connections or crimped terminal lugs. We recommend the use of #6

size ring lugs to ensure secure, reliable connections under severe shock or vibration. Both terminal

blocks have a safety cover which must be removed via two Phillips screws before connecting any

wires. The safety cover must be re-attached after wiring to ensure personnel safety. Refer to Table

3 below for a description of each terminal as well as sections 4.3.1 through 4.3.3 for wiring

examples.

Philips Screw Terminal without Cover

Philips Screw Terminal with Cover

Safety Cover

Screws

Chassis Ground

Connection

Surge / Chassis

Ground Jumper

Terminal

Phoenix Plug Terminal without Cover

Phoenix Plug Terminal with Cover

Safety Cover

Screws

Safety Cover

Chassis Ground

Connection

Terminal

Surge / Chassis

Ground Jumper

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 34 35

Žádné komentáře

Code Alarm 1000SX Instalační příručka Strana 15